Full Pallet Gravity Roller Conveyor - Conveyor frame is 6″ structural steel channel with welded angle iron frame spreaders. Support legs are structural steel channel welded to the underside of the conveyor frame. Threaded rod height adjustment is included. Pallet stop is provided at the discharge end. View Drawing
Right Angle Pop-Up Chain Pallet Transfer – consisting of an extended pitch three (3) strand chain conveyor that rises to accept pallets from an upstream conveyor and then redirects its travel path 90° by lowering it onto a chain driven live roller (CDLR) conveyor for downstream travel. The chain conveyor frame is mounted on four (4) air-boots to enable the roller chains to be raised and lowered between the rollers of the CDLR conveyor section. Pneumatic controls, i.e. solenoid valve and flow controls are included factory plumbed. The conveying speed is 60 FPM on the 3-strand chain conveyor and 30 FPM on the CDLR conveyor. A retro-reflective photo-eye is provided to sense the presence of a pallet and proximity switches are provided to sense the raised/lowered position of the 3-strand chain conveyor. View Drawing
Chain Driven Live Roller Conveyor for Full Pallets - 48” effective width. Conveyor frame and support legs are welded structural steel construction. Rollers are 2½” diameter x 11 gauge tubing with two (2) #60A15 sprockets welded to one end for roll-to-roll transfer of power and they are spaced on 4 3/8” centers. Removable chain guard is provided. A retro-reflective photo-eye is mounted towards the discharge end to sense the presence of a pallet.
Flat Wire Belt Full Pallet Accumulation Conveyor- 48″ wide. Conveyor frame is 6″ structural steel channel with welded angle iron cross bracing. Support legs are structural steel channel with threaded rod height adjustment. Belt tensioning is achieved by take-up bearings with threaded rod adjustment on the tail terminal. The first conveyor zone is powered by a 2 HP x 1800 RPM, TEFC, NEMA “C” face motor coupled to a hollow-shaft, right angle wormgear reducer to give a belt speed of 60 FPM. The second conveyor zone is powered by a 2/1 HP x 1800/900 RPM, TEFC, NEMA “C” face two-speed motor coupled to a hollow-shaft, right angle wormgear reducer to give a belt speed of 60/30 FPM. This matches the conveying speed of Purchaser’s stretch wrapper infeed conveyor. Retro-reflective photo-eyes are mounted at the end of each conveyor section to sense the presence of pallets. Non-reversing magnetic motor starters are provided in the main control panel. View Drawing
Flat Wire Belt Pallet Conveyor with Turntable Base - 48″ wide. Conveyor frame is 6″ structural steel channel with welded angle iron frame spreaders. Idler rollers are spaced on 4″ centers. Belt tensioning is achieved by means of take-up bearings with threaded rod adjustment on the tail terminal. The conveyor is mounted on a large diameter Rotek bearing and can be rotated 90° in the clockwise direction by a pneumatic cylinder. All required pneumatic controls are included as well as a proximity switch to sense when the turntable is in its “home” position. A retro-reflective photo-eye is mounted at the discharge end to sense the presence of a pallet. A reversing magnetic motor starter is provided in the main Logic/Motor Control Panel. View Drawing